LaserUser Forum

Technical support and discussion for CO₂ laser users, including RDWorks, LightBurn, Ruida controllers, maintenance and troubleshooting.
https://forum.laseruser.com/

Hello from Oregon

https://forum.laseruser.com/viewtopic.php?t=5878

Page 1 of 1

Hello from Oregon

Posted: Wed Jul 28, 2021
by Ken Van Etten
I've been using my Chinese 80w for some time now using Lightburn. I've decided to give RDWorks a spin to see what it has to offer. It seems like a good community,

Re: Hello from Oregon

Posted: Wed Jul 28, 2021
by Pete Cyr
Welcome Ken. If you haven’t backed up your vendor settings recommend doing so. They are easily lost and difficult to recover. Most consider Lightburn significantly superior to RDWorks.
All times are UTC+01:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited