Adirondack chair
Posted: Fri Aug 06, 2021
I saw the plans for this in a Fine Woodworking magazine but it looked like it would be fun to scale and laser. This is serial # 1- I did one real quicky from plywood to refine the joints and then this one. I plan two or three more in Walnut for some of my special people and my sweetie who collects miniature furniture- she has a whole wall full of that stuff. It is mostly 1/4" oak plywood with some 1/8" solid oak for the seat. The seat back slats [ .1 x .25"] are cut from 1/4" oak plywood and required a couple of custom tools to position for gluing.
.
.