LaserUser.com Forum (formerly RDWorksLab)

Hello Everyone,

I am Greg Felts and I am brand new to the laser community. I was gifted an OMTech 300x500 CO2 laser that "doesn't work" and after researching it appears the vendor settings were lost as described in the RDWorks Learning Lab 77 video. I have been skimming throughout the forum sand have found so much useful information. I am hoping Russ' 3050 Vendor file helps give me a starting point to get the laser up and running. I look forward to learning more from the forum and hopefully being able to give back as I learn more.

Thanks,
Greg

Welcome Greg - normally I would say be sure to backup your vendor settings - but that is beyond your control.
hope you are able to find a data set that works for your unit