Wind terminal at 10 volts always
Posted: Sat Nov 13, 2021
I have been trying to upgrade my laser with the cloudray ultimate air assist. After have no success I started some diagnostic work and found that the wind terminal to the 24 volt pin reads 10 volts always. I have confirmed machine settings and have both lightburn with air assist enabled and RD Works with if blowing enabled. The status pin does switch back and forth from 0 to 24 volts as expected. In RD works I also confirmed machine settings. Unless I am missing something. But the fact that it is always at 10 volts seems like something is broken internally. Any ideas? Thanks in advance.