Page 1 of 1
Greetings...
Posted: Sun Nov 21, 2021
by Jerry Camel
Hello, all. I am nearing the end of my build based on the Further Fabrication Y-1200 BOM. Using a 6445G controller. The adventure begins...
Re: Greetings...
Posted: Sun Nov 21, 2021
by Pete Cyr
Welcome jerry - Be sure to back up your vendor settings.
Re: Greetings...
Posted: Mon Nov 22, 2021
by Jerry Camel
Thanks, Pete. Is there an export function in the controller? Maybe to USB? Can I do it from LightBurn?
Re: Greetings...
Posted: Tue Nov 23, 2021
by Gene Uselman
The export/save functions are in RDworks as well as Lightburn- details in the FAQ section.