Page 1 of 1
Using U on the R6445G for the rotary....
Posted: Sat Feb 05, 2022
by Todd Suhr
Does anyone on here use U on the R6445G for the rotary??? I have bought another motor controller and have it ready to go. any help with the firmware update would be a big help !!
Thanks for your help!!
Re: Using U on the R6445G for the rotary....
Posted: Sat Feb 05, 2022
by Gene Uselman
I have seen people with this idea over the years but have not heard of any success- you could be the first! Please keep us in the loop.
Re: Using U on the R6445G for the rotary....
Posted: Thu Feb 10, 2022
by Dennis Watson
Yes, I just got mine working this week on my 9 year old Rabbit.
Re: Using U on the R6445G for the rotary....
Posted: Sat Feb 12, 2022
by Frank Small
Dennis
What make/model did you use for a stepper motor and drive?
I have thought of doing this also.
Re: Using U on the R6445G for the rotary....
Posted: Sat Feb 12, 2022
by Dennis Watson
Frank Small wrote: Sat Feb 12, 2022
Dennis
What make/model did you use for a stepper motor and drive?
I have thought of doing this also.
You mean the rotary? It is this one.
https://rabbitlaserusa.com/index.php?ro ... duct_id=94
The driver I used is the same as what came in my Rabbit for the X and Y. Its a Leadshine DM442.
Re: Using U on the R6445G for the rotary....
Posted: Fri Feb 18, 2022
by Dennis Watson
Here is a pic I took of the Ruida connected from the U axis to the U axis driver.
Re: Using U on the R6445G for the rotary....
Posted: Tue May 10, 2022
by Mark Elkins
so you moved the connector from z to u ?