LaserUser.com Forum (formerly RDWorksLab)

Hello friends.

I bought a Rabbit 9060 80w from Ray 9 years ago. Used very little but now I'm retired, and I upgraded it with a new Ruida controller and just this week I added a U axis driver so I don't have to keep swapping the Y cable for the rotary. Looks like it is working fine.

I will post details later.

Welcome Dennis - be sure to back up the vendor setting if you have not as yet.

Pete Cyr wrote: Fri Feb 11, 2022 Welcome Dennis - be sure to back up the vendor setting if you have not as yet.

Oh yes. I have been backing up each time I make a change with a new filename.

Prudent - you may be surprised at how many folks do not.