Oddly spaced horizontal interval lines
Posted: Mon May 30, 2022
Hello, I am at a complete loss with one of my lasers. It's a monport 55w, brand new.
After running tests today I have discovered my issue only happens when engraving bi directionally. It is horribly consistent and happens in every corner of the cutting bed.
I have adjusted belts, inspected pulleys, lowered acceleration speeds, engraving speed/power, and much more. Nothing seems to get rid of it. I am all ears if anyone has a possible solution. I'm thinking there is a controller, stepper, or software issue but I'm not sure.
The attached picture.. lines on the left is with bi directional on and the lines on the right bi directional is off
Thank you
After running tests today I have discovered my issue only happens when engraving bi directionally. It is horribly consistent and happens in every corner of the cutting bed.
I have adjusted belts, inspected pulleys, lowered acceleration speeds, engraving speed/power, and much more. Nothing seems to get rid of it. I am all ears if anyone has a possible solution. I'm thinking there is a controller, stepper, or software issue but I'm not sure.
The attached picture.. lines on the left is with bi directional on and the lines on the right bi directional is off
Thank you
