LaserUser.com Forum (formerly RDWorksLab)

Hi Everyone,

New to CO2 Lasers and what a learning curve this has been. Laser journey started with 10w diode but when that wouldn't etch clear acrylic I was able to find a used OMTECH 60W CO2 Laser. Somewhat used and abused but was able to get it back to a point where it was usable but the engraving is not great. Hoping to be able to find the vendor settings for this laser as I think I may have some settings that are out of whack. Thank you for letting me join the forums. So much to learn and looks like there is a lot of great information here.

Happy New Year!!
Stacy

We usually advise folks to backup their vendor setting but It seems you already know the value of that - the link below might prove useful - be sure to back up what ever you are using before you "fix" it - no telling if these are exactly what you need or not.

viewtopic.php?f=100&t=5634

Hi Peter,
I have learned my lesson for sure. Try to only make the same mistake once. Key word being 'try'. Thanks for the link. I will check it out.

Appreciate your help!
Thank you,
Stacy