OMTECH 60W - Autofocus not enabled after RUIDA update (KT332N)
Posted: Mon May 13, 2024
Hi,
I followed the Omtech recommended upgrade (https://omtechlaser.com/pages/firmware-upgrade) of my RUIDA controller KT332N to V23.01.20. Since then, the focus button (I have autofocus) responds "autofocus not enabled". Does anyone know how to solve this or revert of older firmware by any chance?
EDIT: I found V23.01.05 here: https://mwlaser.com.au/pages/downloads and after flashing this firmware, the autofocus works back again. I've emailed Omtech to get confirmation that the parameters are all aligned with their recommended settings.
I followed the Omtech recommended upgrade (https://omtechlaser.com/pages/firmware-upgrade) of my RUIDA controller KT332N to V23.01.20. Since then, the focus button (I have autofocus) responds "autofocus not enabled". Does anyone know how to solve this or revert of older firmware by any chance?
EDIT: I found V23.01.05 here: https://mwlaser.com.au/pages/downloads and after flashing this firmware, the autofocus works back again. I've emailed Omtech to get confirmation that the parameters are all aligned with their recommended settings.