Page 1 of 1
New here
Posted: Sat Oct 19, 2024
by rcmodelstore
Hi all I’m new here and just looking for some good advise on light burn in that won’t connect via Ethernet
I get it to do a frame fine but when sending a file it says it busy
Re: New here
Posted: Mon Oct 21, 2024
by Gareth Lewis
Hi RCModelStore,
Welcome to the Forum.
Reference your Lightburn issue, I also use Ethernet and it can be temperamental on my system. Couple of things to check;
1. do you have sufficient storage space on your controller?
2. are the connectors fitted securely
3. have you set up your laser system correctly? It needs to be set up as an Ethernet and the IP address on the new device and your laser need to match.