Hi,
Im Roy from north east England and I just picked up a second hand 500x300mm 50W chinese laser a couple of weeks ago. Ive already made a jig to add to the rotary table to keep bottles etc parallel and made 100 perspex keyfobs for work which will go towards recouping my initial machine investment.
I am about to fit a amp meter and will also finish writing some arduino code for a water temperature sensor.
Hi
-
Roy Dickens
- Posts: 5
- Joined: Sun Mar 17, 2019
- Location: Consett
- Country: England
- Nickname: Roy
- Laser Machine Make or Type: Chinese no name
- Laser Power: 50w
- Laser Bed Size: 500 x 300
- Home Position: TL
- RDWorks Version: 8.01.41
- Windows Version: 10
-
Willy Ivy
- Posts: 174
- Joined: Tue Aug 09, 2016
- Location: Pattison, Texas
- Country: USA
- Nickname: Willy
- Laser Machine Make or Type: KH 7050
- Laser Power: 60W
- Laser Bed Size: 12" x 20"
- Home Position: TL
- Control Software: LIGHTBURN
- RDWorks Version: v8.01.18
- LightBurn Version: 1.6.03
- Ruida Controller: RDC6442
- Windows Version: W7 Pro, W10
- Accessories: Hot dog rotary
Gantry powered rotary (plans supplied by Gene Uselman)
Lightburn camera
Homemade chiller (mini fridge)
Ultimate air assist
Dad Burn It Laser (.com) - Contact:
Welcome Roy. Jump right in and check out the FAQ. HAve fun.
PLEASE! 
CONSIDER A DONATION TO THIS FORUM AS THERE ARE COST[s] INVOLVED TO KEEP IT MAINTAINED AND AVAILABLE FOR ALL TO USE. [en]VISION CHINESE LASER HELP WITHOUT IT.https: 
Thank You
Willy
CONSIDER A DONATION TO THIS FORUM AS THERE ARE COST[s] INVOLVED TO KEEP IT MAINTAINED AND AVAILABLE FOR ALL TO USE. [en]VISION CHINESE LASER HELP WITHOUT IT.https: Thank You
Willy