Hello from Quebec La SArre Abitibi

[Yoann Mainville]

Hi, my name is Yoann. I really newer with laser technologie and search to get help. I receive an old china machine with ruida rdlc320-a controller and it was burned. I replace it but get lots of bug to restart the machine. Vendors setting are gone with the old board... Lots of try and retry and still not able to get reallistic move yet.

Hope to find solution with you here

Hve a good day
Yoann

[Pete Cyr]

Welcome Yoann. I normally would recommend backing up you vendor settings but in your case I recommend contacting the folks that sold you th controller and see if they can help and or you can lookin the Vendor settings Forum link below.

viewforum.php?f=100

[Gene Uselman]

Also it is good to know that you can read and change the parameters with Notepad++, a free program, and also they have a free add-on that will compare two files and show where the differences are. I have found that very helpful when I am floundering around trying to troubleshoot a problem.