BUT, I kind of slept, because it was first after I assembled it, I discovered that they ware made for 56mm tubes
Can I just enlarge it to 140% to fit a 80mm tube ?
of cause except the holes for screws, they have to remain the original size.
/Kim
Ross Sadler's tube clamps
-
Kim Bahnsen
- Posts: 5
- Joined: Sat Oct 03, 2020
- Location: Danmark
- Country: Dragoer
- Nickname: Bahnana
- Laser Machine Make or Type: chinese
- Laser Power: 80w
- Laser Bed Size: 130x90cm
- Home Position: TR
- RDWorks Version: 8.01
- Ruida Controller: RDC6445
- Windows Version: 10
I cut one of Ross Sadler's tube clamps, and it came out nice
BUT, I kind of slept, because it was first after I assembled it, I discovered that they ware made for 56mm tubes
Can I just enlarge it to 140% to fit a 80mm tube ?
of cause except the holes for screws, they have to remain the original size.
/Kim
BUT, I kind of slept, because it was first after I assembled it, I discovered that they ware made for 56mm tubes
Can I just enlarge it to 140% to fit a 80mm tube ?
of cause except the holes for screws, they have to remain the original size.
/Kim