New Member..Hello

[Jack Armstrong]

Good Evening and thanks for allowing me to join the group. I'm fairly new to the laser and look forward to obtaining and sharing information. I recently purchased an 80w CO2 laser with 700x 500 bed with a Ruida 6442s controller. The machine is orange and white but I think its very similar to the Omtech versions out there. I am sure I will need some technical guidance with this as there was very little info supplied. As a matter of fact, the vendor settings are completely out of sync on this machine and will need to be reset. Hoping someone has a copy of the settings that can assist e in getting this up and running. Again, thanks for the add.

[Pete Cyr]

Welcome Jack..be sure to back up your vendor settings.