RD works V8 engraving - only outlines

[Palo Cxy]

Hello Every(laser)body:)

I try engraving a few times and everything was ok.
But now, I don't understand what am I doing wrong.

I imported simple drawing with hairlines from CorelDraw2021 like this:
export to .ai
import to RDworks, ok?


Yesterday when I import first time that file everything was ok.
But I need to change one letter in Corel and from that time (its bad that I deleted the first export file)

I don't know whats wrong, how to set up to engraving only outlines.
For example I have now in RDW only one layer for engraving
but part engraving outlines and second part engraving the whole area.

I thing something in corel I changed but I have no idea what?



-------------------------------
I export from corel to .ai
because when I export to .dxf
it always made my drawing very smaller when importing into RDWorks

[Pete Cyr]

in RDWORKS it sounds like your layer is set to cut vice scan

[Palo Cxy]

Please
is there any way I can recognize or verify this idea?

(but one layer
now both parts scan but one part only lines and rest whole
- in this layer)

[Pete Cyr]

cut.png

[Palo Cxy]

Yes I have one layer engraving "scan" and rest "cut"
but part works whole surface and second part only lines - with one scan layer
Its ok?

[Pete Cyr]

your "scan" "output" is set to "NO" - that means it wont process that layer - if you want that layer to scan it must be set to yes

[Palo Cxy]

yes, there was mistake but if I correct nothing changed
Please will be possible to sent you my Corel or RD... file?