Hello
I have been using co2 lasers for years now, I think my newest one is my forth. I have been able to problem solve most of my issues but have come across one that stumps me.
I did a run on engraving with the laser, and all was fine, but when I went to do the next batch of engraving it had no power. My tube had been losing a bit of power for awhile so I thought it was just done, so i replaced the tube. No power still. Replaced power supply still no go. I am using a
RDC644G-B (EC) controller and i see that I have a red light on 15 (GND) with 14 flashing. I have checked all my connections so I have no idea what I need to try next.
new too forum
-
Joseph Hubbs
- Posts: 3
- Joined: Thu Jul 21, 2022
- Location: saskatoon
- Country: Canada
- Laser Machine Make or Type: co2 laser
- Laser Power: 60w
- Laser Bed Size: 18x36
- Home Position: TL
- Control Software: LIGHTBURN
- RDWorks Version: 8.01.18
- Ruida Controller: RDC6442
- Windows Version: 10