Need your Help

[Ian Bell]

Sound advice Pete, although I have found that RDworks sometimes loses it's way, even just by opening it again LOL

can't remember the laser port
changes the order of cutting

[Matthias Roschk]

because i use Solidworks i dont understand why the "S" is open ?
So i tought it could be about the version of RD works

[Pete Cyr]

I assume you created the panel in solidworks - - I am not sure why the S was open either.
I use solidworks as well - it doesn't usually make mistakes - perhaps you captured some stay vector when you exported as a DXF.
I used some software called "Aspire" to correct the issue but I did not pay attention to the specific problem beyond the open vectors.
One other point regarding DXFs - I have found when exporting from solidworks as a DXF and importing to RDWORKS I don't always have a exact dimension in RDWORKS as was created in Solidworks.

I have found exporting to ai in solidworks and importing ai into RDWORKS gives me precise dimensions.

[Matthias Roschk]

Hmm, i also never had problems with SW, but the first time with this special font and there only with this panel.
I will try the "ai" export as well.

Thanks

[Pete Cyr]

My problem were not tied to solidworks..it was how RDWorks imports dxf files...sometime it does well.. sometimes not

[Matthias Roschk]

Hello,

at the end i found the real Problem.
It is not related to Solidworks and also not to RD Works.

I wonder about the Problem, because i had never such Problems, and did a deep research.
Then i found out it is a Font Problem. I tried in SW to put some letters "RETRACT" and "LANDING" into one scetch,
but it did not work. Then i changed the Font to ARIAL MS and with this Font it works.
Still wonder why....
Then i installed a Font Editor and had a deep look into the Font.
Here i found out some Errors in the Font Glyphes. The "A" had in the upper inner part not only 3 lines, it has 5 lines.
I deleted the 2 Lines which are too much and installed the font again and then i was able to put 2 Letters "A" in one scetch and
make a cut future.
Then i did that with all other Glyphes and now it works very fine !!

Matthias

[Gene Uselman]

I have been in Graphics for 25 years and have seen many faulty fonts. Usually with free fonts. Good to keep in mind.