Page 2 of 2
Re: Fill+line is off
Posted: Sat Jul 03, 2021
by Pete Cyr
I don't use lightburn - but can you create two separate layers on scan and one cut and try that?
Re: Fill+line is off
Posted: Wed Jul 07, 2021
by Jack Martin
Nope, tried that one. I am thinking on trying RD works but hate to have to learn MORE new software. Funny the bigger in size the engraving the worse it is. Somewhere in the code numbers are off and not by much either.
Re: Fill+line is off
Posted: Wed Jul 07, 2021
by Pete Cyr
Jack Martin wrote: Wed Jul 07, 2021
Nope, tried that one. I am thinking on trying RD works but hate to have to learn MORE new software. Funny the bigger in size the engraving the worse it is. Somewhere in the code numbers are off and not by much either.
I meant can you try it in Lightburn
Re: Fill+line is off
Posted: Thu Jul 08, 2021
by Jack Martin
Ya I did and as soon as I try it converts back to original....
Re: Fill+line is off
Posted: Thu Jul 08, 2021
by Pete Cyr
Sorry. That sux.
Re: Fill+line is off
Posted: Fri Jul 09, 2021
by Doug Fisher
"Lightburn admitted to me they have a problem they cannot duplicate in 9.24. It seems confined to "fill+line" (scan and cut in RD speak)."
Have you heard back from LightBurn regarding this problem and any solution?
Re: Fill+line is off
Posted: Fri Jul 09, 2021
by Pete Cyr
Jack Martin wrote: Wed Jul 07, 2021
Nope, tried that one. I am thinking on trying RD works but hate to have to learn MORE new software. Funny the bigger in size the engraving the worse it is. Somewhere in the code numbers are off and not by much either.
How about 2 separate files run consecutively - one scan and then one cut
Re: Fill+line is off
Posted: Sat Jul 17, 2021
by Jack Martin
At this point I just won't use fill and line. I got the bong factory to pledge some work my way so other concerns at this point. LB is working on it. I even tried rolling back a few rounds and it still does it. I am wondering if it is my cheap chinese machine. Maybe I need better steppers?