Scanning from the bottom up
Posted: Mon Mar 11, 2019
Post by Frank Meroney » Fri Mar 03, 2017 3:09 pm
Hi All, I did search already so this is my call for help.
Is there a button, check box, dropdown menu, or other option to scan / engrave from "Bottom Up".. on other machines this is an option to reduce deposits back onto the surface.
by Malcolm Lewis » Fri Mar 03, 2017 3:15 pm
Go to "Handle" and select "Cut optimize" from the drop down and the engraving direction check box is on the right.
GDU 3.11.19
I have always changed the Laser head to the lower position in system setup, it has always worked for me.
Hi All, I did search already so this is my call for help.
Is there a button, check box, dropdown menu, or other option to scan / engrave from "Bottom Up".. on other machines this is an option to reduce deposits back onto the surface.
by Malcolm Lewis » Fri Mar 03, 2017 3:15 pm
Go to "Handle" and select "Cut optimize" from the drop down and the engraving direction check box is on the right.
GDU 3.11.19
I have always changed the Laser head to the lower position in system setup, it has always worked for me.