Page 1 of 2
First usable piece ready
Posted: Fri Mar 29, 2019
by Matthias Roschk
Hello,
i have my first piece ready cut and it is usable , as of my Wife
because i dont know what is really for
Also the mm-cale is very exact !!
Matthias
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Pete Cyr
Very Nice and useful...but handmade?
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Jeffrey Aley
Nicely done. I think you can improve your precision by calibrating the backlash on your machine. I notice that your circles are not quite round, and backlash calibration can fix that. Then it will be even better! You might also check your "small circle speed limit". If you do, I'd try to remember to use a lower min power than the max power (in other words, don't use the same value for both).
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Matthias Roschk
Yes for sure, all is Handmade.
First done in Corel the dxf file and then cut.
"Handmade by Roschi" is the Brand of my Wife
Matthias
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Matthias Roschk
Jeffrey Aley wrote: Fri Mar 29, 2019
Nicely done. I think you can improve your precision by calibrating the backlash on your machine. I notice that your circles are not quite round, and backlash calibration can fix that. Then it will be even better! You might also check your "small circle speed limit". If you do, I'd try to remember to use a lower min power than the max power (in other words, don't use the same value for both).
Hello,
the holes are round. Maybe it is a bit from the Foto.
BUt even i am interested what you mean with Circle calibration.
The Cut is done like in the attached picture.
Matthias
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Jeffrey Aley
See
http://atklaser.co.uk/2016/11/21/battle ... -backlash/ .
For the small circle speed limit, see The Manual, Chapter 3.1.
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Matthias Roschk
ahhh... that for are these settings ... thx !!
Even my holes looks round i will check that.
Matthias
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Pete Cyr
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Matthias Roschk
Thanks...will investigate in that.
Matthias
Re: First usable piece ready
Posted: Fri Mar 29, 2019
by Matthias Roschk
Hello,
i tried this , and without any changed settings i get this result.
The corners seams not so "sharp" then in the Picture from the website, but they are in line i think.
Or did you see any failures?
Matthias