Laser Tubes
Posted: Fri Apr 19, 2019
I have a new cheap Chinese 60W laser. I have installed a dual water temperature display for tank temperature and return water temperature, I have also installed a milli-amp meter, 0-30mA. As I mainly cut vulcanized paper I can keep the power down low, between 20-50%.
After reading much on here and watching too many or maybe not enough of Russ Sadler's tutorials, it looks like I should be looking for a replacement tube to keep the machine , I'm sure there are good ones and not so good ones; I'm sure many of you have experience of tube selection.
Also anyone in the Seattle area? Be nice to bounce ideas off another.
Cheers Steve
After reading much on here and watching too many or maybe not enough of Russ Sadler's tutorials, it looks like I should be looking for a replacement tube to keep the machine , I'm sure there are good ones and not so good ones; I'm sure many of you have experience of tube selection.
Also anyone in the Seattle area? Be nice to bounce ideas off another.
Cheers Steve