I designed this after my granddaughter saw the glass one that I posted. It is mostly .25 [.22 actual] clear acrylic with a few small pieces from .125 acrylic. This all uses 1/4" wooden dowel to hold it in alignment and should then be glued. It would look nice with a led light in the base? the trunk is 3-4 pcs of .25 and spacers are .25 and .125- one each toward the bottom layers and get smaller as it goes up- when you like it it is done. There is a star that sticks in the top layer to seal it all off. Enjoy
.
.
Xmas tree cut from acrylic
-
Gene Uselman
- Posts: 2180
- Joined: Thu Jul 07, 2016
- Location: Suburban Minneapolis, Minnesota, US
- Country: USA
- Nickname: Gene
- Laser Machine Make or Type: QC
- Laser Power: 130W
- Laser Bed Size: 900x1300
- Home Position: TR
- Control Software: LIGHTBURN
- RDWorks Version: RDw .19 & Lightburn
- LightBurn Version: Latest
- Ruida Controller: RDC6442
- Windows Version: Win 10 Pro
- Accessories: I have a combining lenses, pin tables [homebuilt], honeycomb tables , wireless remote, Modifed Ultimate Air Assist, home built non-powered rotary device, PrusaMK4 and Mini Prusa printers.
You do not have the required permissions to view the files attached to this post.
If the Help and advice you received here was of VALUE...
Please consider making a donation to maintain the RDWORKSLAB Forum.
The days that I keep my gratitude higher than
my expectations, Well, I have really good days.
Ray Wylie Hubbard- unfortunately deceased
Please consider making a donation to maintain the RDWORKSLAB Forum.
The days that I keep my gratitude higher than
my expectations, Well, I have really good days.
Ray Wylie Hubbard- unfortunately deceased