Xmas tree cut from acrylic
Posted: Wed Dec 04, 2019
I designed this after my granddaughter saw the glass one that I posted. It is mostly .25 [.22 actual] clear acrylic with a few small pieces from .125 acrylic. This all uses 1/4" wooden dowel to hold it in alignment and should then be glued. It would look nice with a led light in the base? the trunk is 3-4 pcs of .25 and spacers are .25 and .125- one each toward the bottom layers and get smaller as it goes up- when you like it it is done. There is a star that sticks in the top layer to seal it all off. Enjoy
. .
. .