Page 1 of 1
Laser not reconizinfg cut
Posted: Tue Dec 10, 2019
by Polly Williams
Just upgraded rdworks from .11 ( everything was fine) to version .22
now laser does not change from engraving (speed / power) to cut speed / power
any suggestions?
Re: Laser not reconizinfg cut
Posted: Tue Dec 10, 2019
by Doug Fisher
First thing I would do is to upgrade to at least 8.01.26 which is the last official release on the English website. If I remember correctly, .22 had some bugs in it.
http://en.rd-acs.com/down_complex.aspx? ... ageindex=2
The Chinese site offers the .40 version.
http://www.rd-acs.com/down_complex.aspx ... ageindex=2
Re: Laser not reconizinfg cut
Posted: Wed Dec 11, 2019
by Polly Williams
Thank You Doug - I will update to 26 and see how that goes