Page 1 of 1
Another Newbie
Posted: Sun Dec 15, 2019
by Dave Vigness
Just getting started. Researched the hell out of lasers, and still didn't research enough. Will probably swap controllers somewhere down the line. Will trudge along with AutoLaser until then. Will welcome the change to RDWorks. Too late to send it back...
Re: Another Newbie
Posted: Mon Dec 16, 2019
by Willy Ivy
Welcome Dave. No matter how much research you did, if you bought a Chinese laser, you are going to do even more now. Good luck, do some reading, searching and ask whatever questions you don't find or understand.
Re: Another Newbie
Posted: Mon Dec 16, 2019
by Gene Uselman
I think that Autolaser is a rebranded RDworks? If the controller sez Ruida, you got the correct controller.