Han's Yueming

[Don Perket]

I have a Han's Yueming Laser CMA1390-t with a 2.2 connection board does anyone know where I can get drivers and software? The OEM is no help.Or I can get a new controller but dont know what would work it has Yarak Y2s3060 m motor drives.

[Jeffrey Aley]

I have a Han's Yueming Laser CMA1390-t with a 2.2 connection board does anyone know where I can get drivers and software? The OEM is no help.Or I can get a new controller but dont know what would work it has Yarak Y2s3060 m motor drives.

Please post a photo of the control panel on the front of the laser. That will give us a hint as to the actual manufacturer of the controller (and therefore the software required).

A photo of the controller itself (inside the laser) would also be helpful (if possible).

[Don Perket]

This is the controller

[Don Perket]

inside the unit.

[Don Perket]

New controller I was looking at is the Ruida RDC644G.

[Tim Mellor]

Still before Coffee this end of the world but a quick look at your motor controllers on Aliexpress and the look like they will work with most controllers including the Ruida https://www.aliexpress.com/i/32684597892.html

Same seller has controllers so maybe send then an inquiry to double check. Time for Coffee to wake the brain cells up ....

[Don Perket]

Thank you That is what I was thinking. It's just CW pulse, CCW Pulse and 5v enable.

[Jeffrey Aley]

I have no idea about this kind of controller, so I don't know where you can get drivers or software. By the way, I notice there's a "Full Spectrum Laser" sticker on it; if this is a FSL unit, you could try contacting them for software (they're in Las Vegas, I think).

Otherwise, I'd rip the controller out and put in a RuiDa.

[Tim Mellor]

Now with a coffee in hand. Quick look at the manufacturers site they 'claim' to have developed their own software http://www.yueminglaser.com/software/index.html which most likely means the control board is theirs too.

If you are running Windows 10 consider running the software in compatibility mode. Lots of the Chinese software still only works well on W7 and earlier. Their software page seems to indicate that too.

Just an out there thing to try with the board however, and this makes a leap that it is a derivative/clone of the Lihuiyu board. My reasoning for this is they have a Coral Plugin mentioned so use their drivers and give Scorchworks a try to talk to the board https://www.scorchworks.com/K40whispere ... perer.html If their software is based on Laserdrw which is hacked from sections of Coraldraw. I doubt this will work but give it a go before you spend $.

[Don Perket]

Got it to communicate using 1.1 from the OEM but when I go to print its like its not moving down. But if I try one in memory it will work.