Lightburn 0.9.10 released

Discussions regarding LightBurn Software
Post Reply
Philipp Pap
Posts: 80
Joined: Wed Mar 15, 2017
Location: Innsbruck
Country: Austria
Laser Machine Make or Type: rdc6445
Laser Power: 55W
Laser Bed Size: 50x30cm
Home Position: TL
Control Software: LIGHTBURN
RDWorks Version: lightburn
Ruida Controller: RDC6445
Windows Version: 10

Here is the big changelog https://lightburnsoftware.com/blogs/new ... -much-more

And one new feature stood out (for me), appart from the new library :
--> Skip shapes that are out of workspace when using Absolute Coords mode <--
I tested this now and it is working. This means I don't have to change the layer of one part, set it as non output, now I can just move it out of the way (ok, there was a solution "only cut selected parts", but it wasn't that practical) !
:D :D
Top
Lightburn Admin
Posts: 58
Joined: Wed May 31, 2017
Location: California
Country: United States
Nickname: LBAdmin
Laser Machine Make or Type: Kehui 700x500 (Ruida controller)
Laser Power: 100w
Laser Bed Size: 700 x 500mm
Home Position: TR
RDWorks Version: 8.0.18
Windows Version: 10
Contact:
Contact Lightburn Admin

We do actually try to listen to suggestions. :)
Top
Philipp Pap
Posts: 80
Joined: Wed Mar 15, 2017
Location: Innsbruck
Country: Austria
Laser Machine Make or Type: rdc6445
Laser Power: 55W
Laser Bed Size: 50x30cm
Home Position: TL
Control Software: LIGHTBURN
RDWorks Version: lightburn
Ruida Controller: RDC6445
Windows Version: 10

Thank you so much for implementing this, I love it already!
If you haven't used Lightburn before and you have a compatible machine, give the demo version a try! (I even hooked up the laser to a camera over a 20 meter active usb cable).
You do not have the required permissions to view the files attached to this post.
Top
Philipp Pap
Posts: 80
Joined: Wed Mar 15, 2017
Location: Innsbruck
Country: Austria
Laser Machine Make or Type: rdc6445
Laser Power: 55W
Laser Bed Size: 50x30cm
Home Position: TL
Control Software: LIGHTBURN
RDWorks Version: lightburn
Ruida Controller: RDC6445
Windows Version: 10

Here are the files, just in case (I should loose them).
You do not have the required permissions to view the files attached to this post.
Top
Robert Edington
Posts: 29
Joined: Fri May 10, 2019
Location: Brenham, Texas
Country: United States
Nickname: RP
Laser Machine Make or Type: 50 Watt Chinese Ebay laser
Laser Power: 50w
Laser Bed Size: 200 x 300
Home Position: TL
RDWorks Version: v8
Windows Version: 10
Accessories: Rotary

Thanks Philipp.
I plan to make one

RP
Top
Post Reply

Return to “LightBurn Discussions”