LaserUser.com Forum (formerly RDWorksLab)

Here is the big changelog https://lightburnsoftware.com/blogs/new ... -much-more

And one new feature stood out (for me), appart from the new library :
--> Skip shapes that are out of workspace when using Absolute Coords mode <--
I tested this now and it is working. This means I don't have to change the layer of one part, set it as non output, now I can just move it out of the way (ok, there was a solution "only cut selected parts", but it wasn't that practical) !

We do actually try to listen to suggestions.

Thank you so much for implementing this, I love it already!
If you haven't used Lightburn before and you have a compatible machine, give the demo version a try! (I even hooked up the laser to a camera over a 20 meter active usb cable).

Here are the files, just in case (I should loose them).

Thanks Philipp.
I plan to make one

RP