Hello from Romania
Posted: Wed Apr 29, 2020
Hi everyone,
I'm Felix. I came here as many others through Russ's youtube videos. After one year of 3d printing I expanded my hobby with a 9060 CO2 laser. I had hard times to calibrate my mirrors only to find out later that my first mirror was almost opaque because of dirt. The first mirror is somehow difficult to check, so my first lesson was to pull off the first mirror from its place. I'm waiting for a 5mW point laser that I ordered yesterday and I hope that it will be much easy to calibrate the mirrors.
Regards,
Felix
I'm Felix. I came here as many others through Russ's youtube videos. After one year of 3d printing I expanded my hobby with a 9060 CO2 laser. I had hard times to calibrate my mirrors only to find out later that my first mirror was almost opaque because of dirt. The first mirror is somehow difficult to check, so my first lesson was to pull off the first mirror from its place. I'm waiting for a 5mW point laser that I ordered yesterday and I hope that it will be much easy to calibrate the mirrors.
Regards,
Felix