LaserUser.com Forum (formerly RDWorksLab)

My laser was working fine until...... I installed the rotary table and did some work. Then I tried to return to my original configuration and no luck. The X axis appears to respond properly The Y axis is not resetting properly and goes VERY slowly. When I load a file and do a frame the X axis frame works OK but the Y axis is very slow and does not reach the extent of the file.

Any suggestion would be appreciated.

Did you reset the feed/rotate function when restoring the y axis

Thank you for your response. Under "Function" I reset the XY axis, X axis, and Y axis. Nothing changed.

Not sure how to reset the feed/rotate function when restoring the y axis but, I will explore.

I have restored my X & Y files from my original backup. Now I receive the yellow error message ""Y Slop Over"

Not sure where to go from here.

Any help would be greatly appreciated.

Thanks

That error message indicates you are too close to the edge of the Y axis boundry and the head does not have sufficient room for the overtravel that will occur for the speed the machine is running.

Move away from the edge 2 or so inches and try again