Programming OUT1 en 2 for Ruida6445G
Posted: Sat Apr 03, 2021
Hi,
Is there a possibility to programming the function of the OUT1 and OUT2 on a Ruida6445G.
When installing a magnetic valve with protection diode everything works on OUT1 but in reverse, so laser is valve off. I do not measure any voltage at the wind output, both when laser on or off. The controller is new (1 month).
Is there a possibility to programming the function of the OUT1 and OUT2 on a Ruida6445G.
When installing a magnetic valve with protection diode everything works on OUT1 but in reverse, so laser is valve off. I do not measure any voltage at the wind output, both when laser on or off. The controller is new (1 month).