Hi all
I have a Chinese Blue 60 40 machine which came with a cheap controller so I have purchased the Ruida 644G controller.
In the vendor settings I have set everything as I think it should be but all is not well.....
For some reason the Breadth sizes I entered into x 600 and y 400 do not get imported into the controller.
The controller shows 10000.0 in both x and y. Do I need to change this on the controller? if so how?
The second issue is I get a "hard limit protection" error when I home the x axis, how do I stop it going back too far?
Any help would be greatly appreciated.
Newbie needing help Ruida RDC 6442G settings
-
Ken Churcher
- Posts: 1
- Joined: Tue Jul 13, 2021
- Location: Angus, Scotland
- Country: United Kingdom
- Laser Machine Make or Type: Chinese
- Laser Power: 60W
- Laser Bed Size: 600x400
- Home Position: TL
- Control Software: RDWORKS
- RDWorks Version: v8.01.49
- Ruida Controller: RDC6442
- Windows Version: 10
- Accessories: None
-
Gene Uselman
- Posts: 2180
- Joined: Thu Jul 07, 2016
- Location: Suburban Minneapolis, Minnesota, US
- Country: USA
- Nickname: Gene
- Laser Machine Make or Type: QC
- Laser Power: 130W
- Laser Bed Size: 900x1300
- Home Position: TR
- Control Software: LIGHTBURN
- RDWorks Version: RDw .19 & Lightburn
- LightBurn Version: Latest
- Ruida Controller: RDC6442
- Windows Version: Win 10 Pro
- Accessories: I have a combining lenses, pin tables [homebuilt], honeycomb tables , wireless remote, Modifed Ultimate Air Assist, home built non-powered rotary device, PrusaMK4 and Mini Prusa printers.
Welcome Ken- Look for Rescue files and pick a machine that is similar to your size and homing position [if possible] There will be instructions on comparing your Vendor settings to the rescue file you select and you can compare the two files. Homing switches will normally be adjustable altho sometime I have seen that they are not. The switch will trigger on a piece of metal [probably] and sometimes that can be adjusted instead of the switch. Good luck, try some of this and repost this in the proper forum- this one is for intros. Gene
viewtopic.php?f=100&t=5836
viewtopic.php?f=100&t=5836
If the Help and advice you received here was of VALUE...
Please consider making a donation to maintain the RDWORKSLAB Forum.
The days that I keep my gratitude higher than
my expectations, Well, I have really good days.
Ray Wylie Hubbard- unfortunately deceased
Please consider making a donation to maintain the RDWORKSLAB Forum.
The days that I keep my gratitude higher than
my expectations, Well, I have really good days.
Ray Wylie Hubbard- unfortunately deceased