Hi from Czech

[Pavel Mrazek]

hello my name is pavel and I live with my family in the Czech republic closer to the south: ) I have at home now a new china co2 laser with a working area 90x60 and a 100W tube which has a control panel rudia RDC6442S 6442G is brand new and today I found out that setting the % performance does not change the settings I feel like the performance is still at the same level today I was doing lines just pointing to the cutout and I had a setting of 1% power and 400mm speed and the material cut through in many places it was a 4mm poplar slip does anyone know if this is some kind of setting or if there might be something wrong with the circuit
I apologize in advance for my poor English

[Pete Cyr]

Welcome Pavel. Be sure to back up your vendor settings. They are easily lost and difficult to recover.
Your English is excellent.

Is this what set up?

cut.png

[Pavel Mrazek]

Hi yes I have it set up exactly like this and it cuts 4 mm poplar but again if I put 100 in and keep the same speed the cut is exactly the same
Just the dealer settings I lost