LaserUser.com Forum (formerly RDWorksLab)

hello my name is pavel and I live with my family in the Czech republic closer to the south: ) I have at home now a new china co2 laser with a working area 90x60 and a 100W tube which has a control panel rudia RDC6442S 6442G is brand new and today I found out that setting the % performance does not change the settings I feel like the performance is still at the same level today I was doing lines just pointing to the cutout and I had a setting of 1% power and 400mm speed and the material cut through in many places it was a 4mm poplar slip does anyone know if this is some kind of setting or if there might be something wrong with the circuit
I apologize in advance for my poor English

Welcome Pavel. Be sure to back up your vendor settings. They are easily lost and difficult to recover.
Your English is excellent.

Is this what set up?

Hi yes I have it set up exactly like this and it cuts 4 mm poplar but again if I put 100 in and keep the same speed the cut is exactly the same
Just the dealer settings I lost