Many problems with the axes ?

[Sascha Pamperin]

Hello, I bought a Vevor 100w Laser Red Black a few days ago and unfortunately something stupid happened to me.
I factory reset the laser without saving anything

it has a working area of ​​900x600 and no longer knows any keystrokes he drives into the housing on X & Y and further if he could.
I have already tried to import some settings from the posts here, unfortunately without good success

Engraving also causes problems - circles are sometimes not round or offset

It is a mystery to me what I have to set where so that it works correctly

[Sascha Pamperin]

Hello again,

Somehow I was able to get him to stay in his work area and also laser circles and squares.

but I have a strong misalignment on several dates...
look at the photo what I expected

ab56d003-da0d-41fa-8a5a-620d049a2c8e.jpg

and what he did

f10e2ac8-8089-47cd-84f4-2bcf2b935fa6.jpg

[Gene Uselman]

Losing the Vendor files is a common problem and can be hard to fix. There are many configurations of similar machines so I would look for files from a similar sized machine [or if you are lucky there may be several]. Try all that you can find and make notes as to which features work on which files. The files can be read by a program called Notepad++ and sometimes you can figure out what different setting actually do.
I would guess you contacted whoever you purchased from to ask for the files? Vevor seems to be a large company- perhaps they can help. If any member has a similar machine perhaps post your Vendor files...