Hello From SW Colorado

[Marty Stecher]

Hi I live in SW Colorado.
My Laser is a Shenhui 900x1200 Dual 60 x 150. The laser heads are mounted on the gantry, side by side, as close as they can go. The General 60 has (or had) the smallest beam in its price range/class and the Reci 150 is the most powerful reasonably priced tube that would fit the frame. The laser uses the 5200 cooler, which has twin out and back water feeds in which I run antifreeze.

I use photoshop to make the vectors from B & W selections. This works very well except where the design has one cut line between 2 different pieces. The selections are all closed shapes, so the resulting vectors are also closed individual shapes. I have used photoshop since 1993.

I am currently moving from a mac running windows 8 under parallels to a cheap laptop running windows 10 pro. My controller is the RD320 so I will need to use an older version of RDworks. I think I had RDCAM ver 6. but I do not remember. I will be working on the vender settings first.

Cheers Marty

[Pete Cyr]

Welcome Marty
Be sure to backup your vendor settings before you alter anything