Hello

[Jeff Thorn]

THANKS FOR HAVING ME. Im a retired guy who knew nothing obout cnc's , lasers or any of this a year and a hlf ago. Lately been enjoying racking my brain figuring it all out, which probably would be impossible without the internet and sites like your s, where people can offer advice to the uninitiated. I started with a my sweetie combination cnc and diode laser . spent 8 months upgrading it to the point where it became two machines. Then moved on to a k40, which I have spent the last year upgrading it to a 12x24 and pritty much have just maxed it out with other upgrades. my
( I Think) final upgrade is now the ruida 6432G. Finally have it working pretty good exept for the air assist wiring. It took forever to get the air assist working on my last board which was a smoothie. But this wiring diagram that comes with the cloudray 6432G is a nightmare and havent had any sucess so far. so That will be my first quest here. Great to be a member !

[Pete Cyr]

Glad to have ya - be sure to back up your vendor settings - they are easily lost/corrupted and difficult to restore.