Hi
I have a Bodor BCL 0605MUF machine that has an RDC6442S controller fitted and also a TP-Link TL-WR802N WiFi unit installed and connected via ethernet cable to the 6442S. The WiFi unit is powered up but aside from the model number there is nothing else visible on it and it is screwed down to the case. ( Photo attached).
I am trying to get it to connect with my laptop using either RDworks or Lightburn but I cannot "see" it as a router or wifi hub, can anyone tell me how I should go about this in a step by step setup if possible.
Thanks for any help
Kev
Looking for help with connecting to the Wifi unit in the laser machine
-
KevanDalby
- Posts: 9
- Joined: Thu Mar 20, 2025
- Location: Portsmouth
- Country: United Kingdom
- Nickname: Kev
- Laser Machine Make or Type: Bodor
- Laser Power: 80
- Laser Bed Size: 600mm x 500mm
- Home Position: BR
- Control Software: RDWORKS
- RDWorks Version: V8.01.18
- LightBurn Version: V1.7.08
- Ruida Controller: RDC6442
- Windows Version: 10
- Accessories: TBA
You do not have the required permissions to view the files attached to this post.