LaserUser.com Forum (formerly RDWorksLab)

Hi all, I am trying to find suppliers for belt replacements for my Bodor BCL-0605MU 90w CO2 laser machine that was purchased in late 2019 and I bought 2nd hand in late 2024. The manufacturer has stopped making and supporting the unit so has been of no help at all. Below is all the info I have been able to get on the current belts but I am looking for a user manual with regards to tensioning the belts and also potential suppliers for belt replacements for all 4 belts. Any help greatly appreciated.

Current Belt Information

Right Side Y-Axis:
Width 8mm ( measured as 8.15mm )
Length Approx 1400mm TBC
Type Open Ended
Marking MXL
Profile Trapezoidal ( Flat topped teeth )
Teeth per Inch 12

Left Side Y-Axis:
Width 8mm ( measured as 8.09mm )
Length Approx 1400mm TBC
Type Open Ended
Marking MXL ( Possibly as marking not seen )
Profile Trapezoidal ( Flat topped teeth )
Teeth per Inch 12

X-Axis:
Width 8mm ( measured as 8.06mm )
Length Approx 1600mm TBC
Type Open Ended
Marking MXL
Profile Trapezoidal ( Flat topped teeth )
Teeth per Inch 12

Z-Axis
Width 15mm ( measured as 14.8mm )
Length Approx 3000mm TBC
Type Closed Loop
Marking HTD 3000 3m
Profile Curvilinear (HTD, arc-shaped" teeth
Teeth per Inch 9

I have attached photos of the belts and the callipers are set at 1"