Hi everybody!
-
Keith Bilo
- Posts: 4
- Joined: Sun Nov 03, 2019
- Location: Hemet, California
- Country: United States
- Nickname: Keith
- Laser Machine Make or Type: Chinese (Same one as Russ)
- Laser Power: 50W
- Laser Bed Size: 500mm x 300mm
- Home Position: TL
- RDWorks Version: 8.01.44
- Windows Version: 10
I'm Keith from California. I've been watching Russ on YouTube for quite some time now, and just recently bought the same Chinese eBay laser that he uses in most of his videos. I joined the forum to learn some new techniques, troubleshoot problems, and maybe even share a bit of the things that I learn while playing around with my laser.
-
Willy Ivy
- Posts: 174
- Joined: Tue Aug 09, 2016
- Location: Pattison, Texas
- Country: USA
- Nickname: Willy
- Laser Machine Make or Type: KH 7050
- Laser Power: 60W
- Laser Bed Size: 12" x 20"
- Home Position: TL
- Control Software: LIGHTBURN
- RDWorks Version: v8.01.18
- LightBurn Version: 1.6.03
- Ruida Controller: RDC6442
- Windows Version: W7 Pro, W10
- Accessories: Hot dog rotary
Gantry powered rotary (plans supplied by Gene Uselman)
Lightburn camera
Homemade chiller (mini fridge)
Ultimate air assist
Dad Burn It Laser (.com) - Contact:
Welcome Keith. There is a lot of good information on this forum that should make things a lot easier and a lot of good guys with plenty of help. Be sure and do all the basics with your new machine such as aligning the mirrors, squaring the machine in all angles, leveling the bed and so on. You will be glad you did all this when it is all working properly. The Chinese don't care if it works properly or not, they just put it together enough to sell it. Good luck.
PLEASE! 
CONSIDER A DONATION TO THIS FORUM AS THERE ARE COST[s] INVOLVED TO KEEP IT MAINTAINED AND AVAILABLE FOR ALL TO USE. [en]VISION CHINESE LASER HELP WITHOUT IT.https: 
Thank You
Willy
CONSIDER A DONATION TO THIS FORUM AS THERE ARE COST[s] INVOLVED TO KEEP IT MAINTAINED AND AVAILABLE FOR ALL TO USE. [en]VISION CHINESE LASER HELP WITHOUT IT.https: Thank You
Willy
-
Keith Bilo
- Posts: 4
- Joined: Sun Nov 03, 2019
- Location: Hemet, California
- Country: United States
- Nickname: Keith
- Laser Machine Make or Type: Chinese (Same one as Russ)
- Laser Power: 50W
- Laser Bed Size: 500mm x 300mm
- Home Position: TL
- RDWorks Version: 8.01.44
- Windows Version: 10
Thanks Willy. I've already begun that process of fixing the machine by aligning the laser, buying new mirrors, adding a new table, etc. I'll have it fixed up in no time
Willy Ivy wrote: Sun Nov 03, 2019 Welcome Keith. There is a lot of good information on this forum that should make things a lot easier and a lot of good guys with plenty of help. Be sure and do all the basics with your new machine such as aligning the mirrors, squaring the machine in all angles, leveling the bed and so on. You will be glad you did all this when it is all working properly. The Chinese don't care if it works properly or not, they just put it together enough to sell it. Good luck.