Wind terminal at 10 volts always

[Keith Larson]

I have been trying to upgrade my laser with the cloudray ultimate air assist. After have no success I started some diagnostic work and found that the wind terminal to the 24 volt pin reads 10 volts always. I have confirmed machine settings and have both lightburn with air assist enabled and RD Works with if blowing enabled. The status pin does switch back and forth from 0 to 24 volts as expected. In RD works I also confirmed machine settings. Unless I am missing something. But the fact that it is always at 10 volts seems like something is broken internally. Any ideas? Thanks in advance.

[Pete Cyr]

The Wind terminal goes to ground when energized.....when the Wind terminal is not energized it is an open circuit - see the following link for more info - Jeffery Aley is a good data source in the follow on string.

viewtopic.php?f=160&t=5684