I need to try update for my Rudia 644XG controller to see if it resolves a problem of "echoing" on some projects. But there are so many links I am not sure what the best or correct one to use is.....
Then how do you get it to the machine? Are there instructions?
I know this seems basic, but don't want to mess up my controller and cannot figure out how to get what version it currently has never mind how to load it.
what is correct version for Rudia 644XG
-
Jack Martin
- Posts: 37
- Joined: Fri May 07, 2021
- Location: Washougal Washington
- Country: USA
- Laser Machine Make or Type: OMTech
- Laser Power: 50
- Laser Bed Size: 12x28
- Home Position: TL
- Control Software: LIGHTBURN
- RDWorks Version: V8
- Ruida Controller: Other
- Windows Version: 10
- Accessories: Rudia RDworks V8, rotory, pass thru
-
Frank Small
- Posts: 73
- Joined: Sun Mar 24, 2019
- Location: Bennington, Vermont
- Country: USA
- Laser Machine Make or Type: 50W China Blue upgraded to Reci 75W tube
- Laser Power: 75
- Laser Bed Size: 500x300
- Home Position: TL
- Control Software: LIGHTBURN
- RDWorks Version: RDW v8.01.18
- Ruida Controller: Other
- Windows Version: Win 10
- Accessories: Ruida Controller R644XG
Rotary fixture
Jack
Are you looking for firmware version or engraving software version?
Frank
Are you looking for firmware version or engraving software version?
Frank
Eleven months of the year I’m an old fat guy but in December I’m a rock star, aka Santa
-
Jack Martin
- Posts: 37
- Joined: Fri May 07, 2021
- Location: Washougal Washington
- Country: USA
- Laser Machine Make or Type: OMTech
- Laser Power: 50
- Laser Bed Size: 12x28
- Home Position: TL
- Control Software: LIGHTBURN
- RDWorks Version: V8
- Ruida Controller: Other
- Windows Version: 10
- Accessories: Rudia RDworks V8, rotory, pass thru
firmware for the controller itself
-
Jack Martin
- Posts: 37
- Joined: Fri May 07, 2021
- Location: Washougal Washington
- Country: USA
- Laser Machine Make or Type: OMTech
- Laser Power: 50
- Laser Bed Size: 12x28
- Home Position: TL
- Control Software: LIGHTBURN
- RDWorks Version: V8
- Ruida Controller: Other
- Windows Version: 10
- Accessories: Rudia RDworks V8, rotory, pass thru
disregard, I found my problem, it was an acceleration issue