Issues with RDWorks
-
Paul Abbott
- Posts: 3
- Joined: Sun Apr 17, 2022
- Location: Melbourne, FL
- Country: USA
- Laser Machine Make or Type: OMTECH ZF2028
- Laser Power: 60w
- Laser Bed Size: 20" X 28"
- Home Position: BL
- Control Software: LIGHTBURN
- RDWorks Version: V8.01.54
- Ruida Controller: Other
- Windows Version: 10
- Accessories: Rotary
My 50W OMTECH is supposed to arrive tomorrow, so in preparation for that I downloaded and installed V8.01.54 followed a day or two later by V8.01.57-20210827 and started investigating it's capabilities as compared to LightBurn. After watching a YouTube video about vectorizing an image I decided to give it a try. I imported a .JPG file and then clicked on the BMP icon. When I clicked on "Get Outline" I got the spinning circle icon for a few seconds and then RDWorks terminated itself. After another couple failed attempts I decided to uninstall and re-install it. All attempts to uninstall RDWorks have been unsuccessful. When I tried to uninstall from Settings - Apps it said there was no uninstall file. Then I went to the RDWorks folder I double-clicked on the Uninstall.exe and it responded with "access denied". Not sure where to go from here. Any assistance would be greatly appreciated.