Hi
To cut a long story very short, I’ve had to replace the Ruida main control box and the PSU for the 5v and 24v on this brand new, never used machine. The control system is a Ruida RDC6442S Controller, and as this machine never fired up, have no backup of the Vender Settings, so it’s stuck with the default factory settings that came with the new controller.
I contacted Vevor, whom I purchased the machine from, albeit some three years ago, but they couldn’t help with the settings, but did reimburse me the cost of the replacement parts, as I could prove the fault was present when I purchased the machine even after this long period.
I was hoping someone on here could help?
It’s a 45w glass tube, and it’s the one in these pictures https://1drv.ms/i/c/ef445d956db26cfd/Ed ... wChVvXo_YQ
Chinese blue and white 3050 laser 45W
-
Daxchan
- Posts: 1
- Joined: Fri Oct 24, 2025
- Location: Bognor Regis West Sussex
- Country: United Kingdom
- Laser Machine Make or Type: 3050
- Laser Power: 45
- Laser Bed Size: 600mm x 400mm
- Home Position: TL
- Control Software: RDWORKS
- RDWorks Version: 8.01.68
- LightBurn Version: 2.0.03
- Ruida Controller: RDC6442
- Windows Version: 10